Is there a product that can be injected into the cavity and expands? filling the cavity completely and strengthening the wood as well while keeping the bees out for good? Very frustrated and it seems none of the youtube videos or on-line advice addresses this specific problem. I have tried to fill them with wood putty, but it’s not pliable enough and too messy (get’s all over the place and not enough in the hole) and I can’t tell if the putty has fully filled the cavity. I have tried injecting liquid wood but it just pours out. I have stuffed the holes with steel wool and plugged the hole with wood putty, but I’m concerned that will not strengthen the beams enough. I have been trying numerous methods to fill the holes while strengthening the beams as they hold up the roof and would be impossible to replace. The outside parts of the beams have suffered from carpenter bee infestations, so much that there are numerous holes in each beam and the tunnels extend into the beams up to a foot or more to the left or right of a hole. The house we bought has redwood beams that extend from outside the house to inside. Here's how to foil their destructive abilities:- The Amish Bee Trap mimics a standard nest. Placing the traps up at the beginning of spring will stop carpenter bees from nesting in your home! What to do Amish Bee Traps are an inexpensive yet effective preventing damage from Carpenter Bees. They are clearly great spots for carpenter bee nests, so you’ll want to prevent new nests. PRO TIP: Once your nests are plugged up and secure, remember those locations for the spring. The holes could have brown stains around them, or wood shavings dropped from the holes. Deck and porch railings are also ideal places for the bees to nest. You’ll need to look for ½” holes around the eaves and corners of your home. Wait for the caulk to dry and paint the now patched hole to match your home.īe sure to find all your carpenter bee nests.Squeeze caulk into the hole and wipe flush with the exterior.If you use the wooden cork, move to step 3 (caulk) and push the wooden cork in place after.If you rather skip the wooden dowels, you can use our wooden corks designed to fit carpenter bee nests.Cut the last dowel piece to be flush with the exterior. Cut your wooden dowel into ¾” pieces and push as many as possible into the nest.This is completely up to your preference, as we have found using the rubbing alcohol to be effective. Some people like to treat the holes with pesticide to make sure the larva are killed.This will remove the air in the nest and suffocate the larva.Stuff the cotton ball soaked in rubbing alcohol as far down the nest as possible.
0 Comments
Leave a Reply. |